Sound Technology

04/03/2026

Customer did not pick this up. Will let this go for the cost of repair.

04/01/2026

03/10/2026

Commercial sound system

01/15/2026

Serviced at Sound Technology Inc.Customer is going to sell one of two

11/24/2025

Wrapped up this absolutely legendary Ampeg Bass Amp Friday. This got the full works with new Electrolytic Caps, a full re-tube with Tung-Sol Reissues and an upgrade to 5881 Output Tubes. The original power cord was replaced, lamps were upgraded and full alignment and bias. Tyler did a fantastic job on the unit. After the upgrades there is much more power and headroom. It still maintains its vintage tone which was critical. The photos and video speak for themselves!

09/21/2025

Incorporated in the state of Florida 1975 

06/10/2025

Early morning service call at the Hard Rock Hotel and Casino 

02/14/2025

Working on this legendary Sansui AU-717 amp. It has the dreaded "Brown Goo" which is what the originally installed adhesive glue they used on these back in the late 70's turned into. That glue will eventually eat the board, damage traces and corrode components. It needs to be cleaned from all boards in this unit. That's exactly what we did. It received a full electrolytic cap replacement while we were in there. Back to cranking out its underrated 85 W/channel. The before and after pics speak for themselves.

02/10/2025

This monster McIntosh Amp hasn't been touched since new. The original lamps were all out and the gels for the VU meter had discolored. An LED lamp upgrade and new gels has it looking brand new once again.

01/08/2025

Appreciate everyone's patience as the shop deals with a rough Flu outbreak. Whatever has been going around has hit the shop hard over the last couple of weeks. I'm in the shop answering phones but repairs have ground to a halt as all but 1 part time tech are out with illness. We thought we were past it this week but I had send 2 of the techs home as they clearly aren't ready to be in just yet.

Thank you all for your continued support. We will be back hard on the bench, hopefully sooner rather than later.

Send a message to learn more

10/22/2024

Sometimes its good to give us things to look over, even if it's working well. Case in point with this Sansui 5000A where the glue used to attach the thermal feedback devices to the heat-sink has become conductive and corrosive. While the unit was still currently functioning, it could have been catastrophic if not addressed immediately. Lucky for this gentleman. We will clean up what we can and replace what we can't!