Amor I.T. Solutions

Amor I.T. Solutions We are an Information Technology Company that focuses on Networking Installation, I.T. Consulting as well as Security Camera Installation.

We installed a wireless access point, security camera as well as a network switch.
10/06/2026

We installed a wireless access point, security camera as well as a network switch.

Client stated his wireless signal was not very good throughout his home. Client had several rooms wired with telephone j...
09/26/2026

Client stated his wireless signal was not very good throughout his home.
Client had several rooms wired with telephone jacks. The cabling used was Cat5e.
We removed the face plates and terminated for In-Wall U7 wireless access points, 4 in total.
All the Cat5e cables were run to the garages utility room. Client asked us to install and shelve where we placed the UniFi Router, switch and Charter spectrum modem.

Amor I.T. Solutions
Work: 231-944-0799
Email: [email protected]
Website: https://www.AmorITSolutions.com

Trenched 200 feet, installed 1 1/4 inch conduit with a pull string into the ground. Ran Starlink network cable through c...
09/16/2026

Trenched 200 feet, installed 1 1/4 inch conduit with a pull string into the ground. Ran Starlink network cable through conduit, one end into the clients cottage other connected to his Starlink mounted to a pole.

Amor I.T. Solutions
Work: 231-944-0799
Email: [email protected]
Website: https://www.AmorITSolutions.com

Replaced clients 10 year old camera system with UniFi Protect Network Video Recorder Instant Kit. We installed a 18TB WD...
09/08/2026

Replaced clients 10 year old camera system with UniFi Protect Network Video Recorder Instant Kit. We installed a 18TB WD Purple HDD which gave them approximately 40 days of recording.

The client had 4 outdoor security cameras, where 2 of them were not functional.

Question from a client:I have older WiFi 5 wireless access points and thinking about getting newer WiFi 7 access points....
08/24/2026

Question from a client:

I have older WiFi 5 wireless access points and thinking about getting newer WiFi 7 access points. I have 6 total throughout my home should I replace a few of them or should I replace them all?

Answer: It is best to replace all 6 if your budget allows. Things to keep in mind.

Backward Compatibility: Wi-Fi 7 access points work fine with older Wi-Fi 5 devices.

Infrastructure Bottlenecks: Wi-Fi 7 access points need faster 2.5GbE or 10GbE switch ports and higher Power-over-Ethernet (PoE) budgets to reach top speeds, which may force a wider network upgrade.

Range Constraints: The new 6 GHz band used by Wi-Fi 7 has a shorter range and weaker wall pe*******on than 5 GHz, meaning proper placement matters more than total replacement.

Device Support: Most older phones, laptops, and smart home gadgets cannot use Wi-Fi 7 features, so they will not see major speed gains from a blanket upgrade.

Again if budget allows we recommend to replace all the access points at the same time.

Gone are the days of boring residential doorbells. Modern day ones have video cameras attached to them.Video doorbells g...
08/24/2026

Gone are the days of boring residential doorbells. Modern day ones have video cameras attached to them.

Video doorbells give you things like SMS notifications, 2 way audio, Motion and Full time video.

Using Cat5e connectors on a cat6 network cable is not advised. Client had his electrician terminate them. Cat6 uses thic...
08/20/2026

Using Cat5e connectors on a cat6 network cable is not advised.

Client had his electrician terminate them.

Cat6 uses thicker 23 AWG wire that often fails to fit into the narrow channels of Cat5e plugs, and mixing them lowers your network performance to Cat5e speeds. Always match your connectors to the cable category.

We replaced them with cat6 connectors.

08/09/2026

Hiring Us for Managed I.T. Services

What not to do when running network cable for your home or business: Recently we had a customer contact us about setting...
07/24/2026

What not to do when running network cable for your home or business:

Recently we had a customer contact us about setting up some networking equipment for his home. When we arrived we saw network cable (Cat5e) ran along side some electrical wire. The customer had done all the wiring himself.

It's always good practice when running low voltage wire like network cable Cat5e, Cat6 to separate to prevent electromagnetic interference.

You never want to bundle electrical wire in with network cabling. You want to make sure that you keep your network cable at least 8-12 inches from household electrical cables. Now some cables are shielded that can help with interference but a good rule of thumb is to always try and keep the cables away from each other as much as possible. If you have to cross paths do it at 90 degree angles avoiding running the network and electrical cables parallel to each other.

Running network cable to close to or along side electrical cable can cause slower network speeds, and or dropped connections.
It's always a good idea to ask or hire an electrician or low voltage technician if you plan to wire your home or business.

At Amor I.T. Solutions we specialize in structured low voltage cabling. If you need assistance with your project you can contact us with the information below.

Amor I.T. Solutions
Work: 231-944-0799
Email: [email protected]
Website: https://www.AmorITSolutions.com

Address

10600 E. Pobuda Road
Suttons Bay, MI
49682

Opening Hours

Monday 9am - 5pm
Tuesday 9am - 5pm
Wednesday 9am - 5pm
Thursday 9am - 5pm
Friday 9am - 5pm

Telephone

+12319440799

Website

Alerts

Be the first to know and let us send you an email when Amor I.T. Solutions posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Amor I.T. Solutions:

Shortcuts

Share

Category