Jove's Wonders

10/03/2026

After the dust clears, reach into your Nuka Cola Machine for your favorite commander deck to slay your foes.

09/19/2026

Keep you most valued treasures secured with Vaultec!

09/07/2026

08/30/2026

A recent storm left my Voron 2.4 completely unresponsive—black display, no web interface, and zero signs of life. ⚡️❌
​Before tearing down the Manta board or throwing money at new parts, I was able to take a deep dive into the logs because the board powered up. Klipper crashed on boot because it lost connection to the toolhead board (EBBCan), leaving the whole machine seemingly paralyzed.
​I pulled out a spare board ready to swap it, but the original hardware actually survived! The power drop just wiped the MCU's communication configuration.
​All it took was jumping into SSH, running make menuconfig to rebuild the firmware file, flashing it back over CAN, and restarting the system. No hardware swap required! 🛠️🖨️✨
​📺 Full 27-minute step-by-step diagnostic masterclass and firmware rebuild tutorial is under wraps now on the channel! Link in bio!
​

08/23/2026

The Voron is down. I repeat. The Voron is down!

Last year I bought the Chaoticlab Carbon Fiber Bracket Kit for Voron 2.4 R2 (Amazon ASIN/Label Code: X004LO1M4Z) on September 5th. I've managed to put enough stress on it to mangle it up pretty good. I noticed it started making some clicking noises and decided to investigate. While doing so all XY travel seized up. Upon closer inspection I found one of the internal 20T toothed idler bearings in the AB mount assembly recently seized up after extended use. Before I caught it, the seized bearing race spun against the red anodized idler pin/shaft, causing severe scoring and wearing down the metal shaft diameter.

I sent an email [email protected] because I don't know if these are available. We will see.


Jove's Wonders

08/18/2026

These deck bixes are getting serious. More to come depending on feedback.

08/18/2026

New deck cases are printing everyday now. Check back soon as we get the store opened up and more become available.

06/04/2026

New deck box for fam. We installed a new nozzle on the v6 and lost all layer lines. I'm really pleased with the quality on these. It looks like we're ready for production.

04/17/2026

Hitting the water today with this print!

04/05/2026

AIIO Yak Junk and drink holder - the AIO Sup Cup

Can't wait to field test this handy holder that stays in place using your kayak tethers.

https://www.printables.com/model/1371488-all-in-one-sup-cup-nc-edition

Props to