Nixie NZ

Nixie NZ Makers of the finest looking and sounding Tube Amplifiers. Repairer of electronics / audio equipment

Built right here in Wanaka - New Zealand, implementing the best components sourced from around the world.

Naim Nait 3 Re-Cap
29/03/2026

Naim Nait 3 Re-Cap

Fender Hot Rod Deluxe in for a re-Cap, a reverb issue and a re-bias.
21/03/2026

Fender Hot Rod Deluxe in for a re-Cap, a reverb issue and a re-bias.

14/03/2026

Kanto Powered Speaker Repair








Nixie NZ

More James Audio custom grilles made up on the CNC for Custom Digital to perfectly match the timber ceiling. These will ...
10/03/2026

More James Audio custom grilles made up on the CNC for Custom Digital to perfectly match the timber ceiling. These will be close to invisible when installed. The removable grilles give access to a removable MF/HF module within the sealed aircraft grade aluminium bass enclosure

This Sony N9000ES - beast of a power amp came in "not coming out of warm up" found a single 1ohm metal oxide fusible res...
10/03/2026

This Sony N9000ES - beast of a power amp came in "not coming out of warm up" found a single 1ohm metal oxide fusible resistor responsible/ measuring open circuit. Due to being a specific inflammable protection device, more have been specially ordered but looks like it will live on!

This Creek 4040s2 Integrated had blown B+ fuses, shorted output transisitors on the left channel, as well as drive trans...
10/03/2026

This Creek 4040s2 Integrated had blown B+ fuses, shorted output transisitors on the left channel, as well as drive transistors and heaps of high ESR caps. Now working sweet again, and idle current set to spec 👌

A Fender Blues Junior in for a service / hum problems
22/02/2026

A Fender Blues Junior in for a service / hum problems

Just completed a full resto on this Pioneer SA-7100 Integrated Amp. 70+ components replaced inlcuding a full re-cap, a l...
16/02/2026

Just completed a full resto on this Pioneer SA-7100 Integrated Amp. 70+ components replaced inlcuding a full re-cap, a lot of the transistors and new trimmer pots. And of course, cleaned up the silver face and k***s.
Re-biased and adjusted DC offset to spec. Now to listen!

An old job has returned for some modifications - A passive pre using the Shlagle auto transformer attenuators. All pure ...
13/01/2026

An old job has returned for some modifications - A passive pre using the Shlagle auto transformer attenuators. All pure silver internal hook-up wiring, a coarse and a fine attenuator for each channel. An additional L&R RCA has been added for bi-amping purposes to power the Lii Crysyal 6 in a Le Cleach horn as well as the Lii Origin S-10 Full Range loudspeakers

This Sansui AU-519 has just left the workshop after a service. A re-cap had been done prior but several had been missed....
07/01/2026

This Sansui AU-519 has just left the workshop after a service. A re-cap had been done prior but several had been missed. A zener in the phono power supply had been corroded through by old eletrolytic juice and DC offset & bias were out & output transistors were not snug against heatsink. Now coming out of protection and sounding great!

Sansui AU-519 on the bench for repair. Stuck in protection mode..
30/12/2025

Sansui AU-519 on the bench for repair. Stuck in protection mode..

Address

18 Cooper Crescent
Luggate
9305

Telephone

+64212446681

Website

Alerts

Be the first to know and let us send you an email when Nixie NZ posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Contact The Business

Send a message to Nixie NZ:

Shortcuts

Share

Category