Repair Your Computers and Laptops

18/11/2018

07/08/2018

Send a message to learn more

07/08/2018

TO MAKE USER ACCOUNT USING “CMD”

ON WINDOWS VISTA or WINDOWS 7, 8, AND 10
Click START, search for "CMD" and press ENTER.
Now, in the command prompt window, type NET USER /ADD [USERNAME] [PASSWORD] then press enter.
EXAMPLE IN: - NET USER /ADD [TECHNO-BYTE] [PASSWORD] (ALL WILL BE IN LOWER CASE

ADD USER as ADMINISTRATOR

Click START, search for "CMD" and press ENTER.
Now in command prompt window, type NEW LOCALGROUP ADMINISTRATORS [USERNAME] /ADD Then press enter.
EXAMPLE IN: - NEW LOCALGROUP ADMINISTRATORS [TECHNO-BYTE] /ADD (ALL WILL BE IN LOWER CASE)

ENABLE or DISABLE LOCAL USER ACCOUNT

Click on START MENU then choose “RUN”.
Type “CMD” and press Enter to run command prompt.
Right Click on command prompt Icon in the Taskbar, and then choose “RUN AS ADMINISTRATOR”.
Now in command prompt window, type “NET USER USERNAME /ACTIVE: NO”.

Example: - NET USER ANKIT /ACTIVE: NO (ALL WILL BE IN LOWER CASE)

To enable the account again, run the following:

NET USER USERNAME /ACTIVE: YES

Send a message to learn more

26/07/2018

We need part time Sales or Marketing executive for a startup in Lucknow.

30/05/2018

FIXING ORANGE LIGHT OF DEATH ON DELL OPTIMEX 780

07/05/2018

HOW TO FIX DNS SERVER ERROR WHILE GOING ON INTERNET

SYMPTOMS:-
On a computer that is running Windows 7, you receive the following error message “YOUR COMPUTER APPEARS TO BE CORRECTLY CONFIGURED BUT THE DEVICE OR DNS SERVER IS NOT RESPONDING “When this issue occurs, you cannot connect to Internet.

RESOLUTION
To troubleshoot this problem, try one or more of the following methods.

METHOD 1: RESTART THE ROUTER

• Remove the power cord from the router.
• Wait at least 10 seconds after all lights on the router have gone out.
• Reconnect the power cord to the router.

METHOD 2: CONFIGURE THE TCP/IP SETTINGS

Configure the TCP/IP settings. To do this, follow these steps:
1. Select START > CONTROL PANNEL
2. Select VIEW NETWORK STATUS AND under NETWORKING AND INTERNET.
3. Select CHANGE ADAPTER SETTINGS.
4. Press and hold (or right-click) LOCAL AREA CONNECTION, and then select PROPERTIES.
5. Select INTERNET PROTOCOL VERSION 4(TCP/IPv4) > PROPERTIES.
6. Select OBTAIN AN IP ADDRESS AUTOMATICALLY > OBTAIN DNS SERVER ADDRESS AUTOMATICALLY> OK.

METHOD3: USE THE IPCONFIG COMMAND

Use the Ipconfig command-line tool. To do this, follow these steps:
1. Select START, type commands prompt in the SEARCH PROGRAMS AND FILES box, press and hold (or right-click) COMMAND PROMPT, and then select RUN AS ADMINISTRATOR.
2. At the command prompt, type the following commands. Press Enter after each command.

ipconfig /release
ipconfig /renew

After typing these commands you will get a positive message then restart the computer and DNS SERVER ERROR problem will be resolved

14/04/2018

HOW TO DISASSEMBLE AND REASSEMBLE DESKTOP COMPUTERS

This Video will teach you how you can disassemble and Reassemble your Desktop computers in order to troubleshoot the problems.
Most of the problems occur because of the dust on the computer parts so doing this way you can clean the dust from the computer parts and this will fix lot of problems of Desktop computers. Following these steps you can troubleshoot lot of problems of your desktop computer like.

1. You are getting only grey screen with no message
2. You are not getting display on the computer screen
3. Computer is getting restart automatic in few minutes.
4. If Your hard disk is fine but it is not detected by the computer (in some cases only)