GB7AC DMR Repeater Argyll and Clyde

GB7AC DMR Repeater Argyll and Clyde This page has been created to discuss all things GB7AC related.

08/04/2026

Update: new sim installed set for another year.

I've also adjusted the analogue squelch tail so it's much shorter than before.

We are discussing whether to keep analogue capability on the repeater. I'm not so sure anyone uses it?

Please let us know your thoughts in the comments below

27/03/2026

Battery is at 100%

28/01/2026

Repeater update: We are currently offline to get some juice from the sun. Down at 0% overnight bit recovering well this morning. Mon the 🌞

24/12/2025

Good news.. we're back on and operational.

Merry Christmas from the GB7AC team

12/12/2025

Update: We have switched off the repeater for now as the batteries are low due to lack of sunlight recently. Fingers 🤞 we get some sun in the next few days to bring her back online.

29/10/2025

The nights are fair drawing in.. when means less power to the batteries 🫣 So far everything is working fine, but we may need to reduce operating times moving forward.

Any update to this will be posted here and on the Brandmeister dash

As the winter months approach, it's time to get some remote visibility on what the battery is doing at the repeater. New...
21/08/2025

As the winter months approach, it's time to get some remote visibility on what the battery is doing at the repeater. New battery shunt installed 😀

19/05/2025

We've had some feedback regarding the carrier tail while using AC in analogue - its way too long. This will be resolved on next site visit.

It's great to see the repeater being used in both modes!

A new TELTONIKA RUT-950 commercial grade 4G router installed this evening at GB7AC. We are hopeful it will outperform th...
28/04/2025

A new TELTONIKA RUT-950 commercial grade 4G router installed this evening at GB7AC. We are hopeful it will outperform the previous consumer grade device we were using 👌🏻

07/04/2025

Just a wee reminder that GB7AC is dual mode running DMR and Analogue FM! Remember to put in a CTCSS tone on both TX and RX (103.5Hz) to access and filter out any digital traffic on the repeater

And we're back... the new community funded box was installed today. Many thanks to Mr Allister Watson for all your ass...
01/04/2025

And we're back... the new community funded box was installed today. Many thanks to Mr Allister Watson for all your assistance, quality coffee and banter today 🙌🏻

Address

Largs

Website

Alerts

Be the first to know and let us send you an email when GB7AC DMR Repeater Argyll and Clyde posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share

Category