18/08/2025
🔌 Typical Installation of Enertia Smart Saving Device
✔️Location:
Installed close to the main breaker panel for maximum efficiency.
Connections (single-phase residential supply, 220V in PH):
Line (Live/Hot) from the main breaker → device input terminal L.
Neutral (or Ground depending on model) → device input terminal N/G.
Some models specify Line-to-Line connection (across both live wires in a split-phase 220V system).
Some specify Line-to-Ground connection, where the device stabilizes power by referencing the ground.
✔️ Breaker Protection:
The device should be protected by its own breaker (usually 15–20A) connected in parallel with the main breaker lines.
This ensures you can isolate the device if needed.
✔️Grounding:
Ensure the ground wire is properly bonded to the building’s grounding system.
Never connect neutral and ground incorrectly (they only bond at the service entrance).
✅ Simplified Idea:
You’re basically installing the Enertia device in parallel with your electrical system at the main breaker (not in series).
Line → Device
Neutral/Ground → Device
The device then helps regulate, filter, and stabilize current flow.